Weave Along Weaving Techniques

Weave Along || Part 3: Twining Triangles

New to the Weave Along?  This is a set of posts that help you learn to weave step-by-step! Find all the Weave Along Steps here.

Weave Along || Part 3: Twining TrianglesNext in our weave along we’re going to add a twining example of triangles (yes it was a terrible pun, but when a terrible pun comes unexpectedly into your life you just have to share it). 


Before weaving anything fancy, I put in a few rows of the plain weave. This helps secure my warp threads and give the weave structure. When we made the Spanish lace, there were spaces between the warp threads where the weft did not pass straight across. And that’s ok, but if we were to only weave the Spanish lace and take the weave off the loom, you’d see that the warp threads would separate a bit because there isn’t much pulling them together where the gaps are. I would like this weave to have structure to it, so I added the plain weave rows.

I think plain weave rows also help frame the Spanish lace and draw your eye to it.

So here are the next steps:

Weave Along || Part 3: Twining Trianglesstep 1|| using your thread where you left off at the top of the last Spanish lace bring the thread down and under the end warp. Then weave the plain weave (under, over, under, etc). Across all the warp threads. Weave a total of 3 rows of the plain weave. You can see as we add the rows of plain weave the warp groupings are separating and our warp threads are becoming more evenly spaced.

step 2|| take two pieces of thread measured out to the same length. Then tie them in a knot, leaving 2-3 inches of a thread tail.

Tip: I measure using my forearm, holding one end of the thread and then wrapping from my hand to my elbow about 3 times. This amount of thread is usually more then enough for me when weaving a section.

Weave Along || Part 3: Twining Trianglesstep 3|| put one thread under the end warp and one thread over the end warp and pull both threads until the knot you tied catches on the warp thread. This knot is just going to be used as an anchor for our twining. We’ll untie it later and secure the thread ends.

Weave Along || Part 3: Twining Trianglesstep 4|| the process of twining is basically passing one thread over, under, over, etc while passing the other thread under, over, under, etc. And at the same time twisting those two threads around each other when they cross in the space between warp threads.

To do this I follow this pattern (thread that starts over the end warp is thread #1, thread that starts under the end warp is thread #2)

  • pull thread #2 over the next warp string and let it sit up above thread #1
  • bring thread #1 under the next warp and then out again so it sits on top of the warp threads
  • pull thread #2 down over thread #1
  • pull thread #1 up above, pass thread #2 under the next warp and then out again so it sits on top of the warp threads.
  • continue this twisting pattern all the way across the warp threads. If you need more details, I wrote about twining here.

Weave Along || Part 3: Twining Trianglesstep 5|| once you have twined across all the warp threads, you may have a wiggly line like I do. Take your weaving needle and pushed the twinning thread to an upward diagonal over 4 warp threads, the 5th warp thread should be the peak of the triangle, then push the next 4 warp threads in a downward diagonal. Repeat this pattern repeated across the warp threads so that your last diagonal ends going up 4 warp threads.

Weave Along || Part 3: Twining Trianglesstep 6|| after you have made the triangular shapes tie off the two threads at the end warp. This is to hold the threads in place. We’ll untie it and tuck the ends later.

We’re keeping the light lacy feel to this weave, but we’ve added some structure. The twining is much bolder, because there are no warp threads showing alone our twining line. We’ll build on this more next week. Find all the Weave Along Steps here.

Happy Weaving!

Kate


||Shop This Post||


For more fun, follow me here -> pinterestinstagram

You Might Also Like

  • Shirah Miriam Aumann
    May 4, 2017 at 5:52 pm

    Hi Kate. Thank you for all you do to share your techniques with us and keep us weaving. i was wondering if you have ever tried the twining with a needle. I have trouble with controlling the two at the same time with just my fingers (old fingers! 🙂 ) You do a row of plain weave (I start from the left selvage since my right hand is dominant) and when you reach the right selvage, you reverse direction in kind of a rocking motion to go over a warp and then under the first shot in the space between warp and the next warp and then over the next warp, etc. I am finding it much harder to describe than it is to accomplish it. It is like needle weaving in a rocking motion to produce the stitch – the twining stitch – as you do with the two at once. I used to only do my soumak and reverse soumak with two passes until you taught the method of starting from the left selvage with two pieces of weft to accomplish the same stitch. Fun to learn new techniques and different variations… Mimi

    • Kate
      May 5, 2017 at 1:39 pm

      I never tried it with a needle, I can imagine how using a needle would be easier on the hands. I should try this sometime and see how it works. Thanks for the suggestion!

  • Paulette
    May 6, 2017 at 7:29 am

    Hi Kate…really really enjoy your blog!!! I made a loom with wood and nails, and it is working out GREAT!! The only thing, I think, that I messed up was getting the “warps” too close!! I am dealing with it and weaving away!! I will make another when I finish this one, with warps not so close. I think these are about 1/8″ apart, if not smaller??Yeah pretty close!! But for a first timer, I am gonna finish it!! My question for you is WHERE do you get the “roving”, the fluffy cotton like material? I sure hope I am using the correct “WORDS” for the weaving community?? LOL!! Thanks for all your knowledge in this fun craft!!

  • maria leticia rodriguez maldonado
    May 6, 2017 at 3:42 pm

    simplemente hermoso de precioso, felicidades, me encanto

    • Kate
      May 9, 2017 at 9:56 am

      muchos gracias!

  • Audrey Wolter
    May 7, 2017 at 11:14 am

    Has the weave along started? Where do I. Find the instructions? What materials are needed?